admin
A caned candle holder adds woven texture and a warm, natural look to a room. This simple DIY project layers cane webbing over a glass hurricane candle holder, so the glass supports the delicate material while creating an attractive accent for a table or shelf.
Cane is a flat reed material from the rattan family, commonly woven into decorative patterns or a simpler mesh. Since it can be damaged by repeated direct pressure, using it as an exterior covering rather than a structural part helps protect it. Before starting, check that your cane webbing is flexible enough to wrap around your glass holder.
Materials for a Caned Candle Holder
Gather the supplies before cutting. Working with a clean, dry glass surface will help the hot glue adhere more effectively.
- Glass hurricane candle holders
- Hot glue gun and hot glue sticks
- Cane webbing in your preferred style
- Flat oval reed, 1/4-inch wide
- Sharp scissors
- Optional: masking tape to hold reed strips in place as the glue sets
How to Make a Caned Candle Holder
1. Measure and cut the cane webbing
Wrap a section of cane around the circumference of the glass hurricane and cut it to length. Aim for the edges to meet neatly at the back. If the webbing has been stored rolled, it may curve around the glass more easily. Measure the height of the holder and trim the webbing to fit.
Practical tip: Test the fit around the glass before applying glue. Small adjustments are easier to make before the cane is attached.
2. Secure the cane at the seam
Use a small amount of hot glue to attach the cane where its edges meet. Keep the glue along the seam and avoid applying more than necessary, as excess can squeeze through the webbing or remain visible on the glass.
3. Prepare the flat reed trim
Cut three pieces of flat oval reed for each hurricane: one for the top edge, one for the bottom edge, and one to cover the vertical seam. Initially cut each piece a little longer than needed; you can trim it for a closer fit during installation.
4. Glue the trim in place
Apply hot glue to attach the reed around the top and bottom edges, then add the strip along the seam. Trim the ends carefully so they meet cleanly. Masking tape can help hold a strip in position while you work around the glass.
Once the glue has cooled, check that the cane and trim are secure. The finished holders bring texture to a coffee table, shelf, or dining table centerpiece, and making several in different sizes can create a coordinated display.
Using and Caring for Your Caned Candle Holder
Cane is a delicate decorative material, so avoid pressing or rubbing it while moving the holder. Keep the cane and reed trim away from direct contact with a flame, and follow the candle and glass holder manufacturers’ safety instructions. For an added safety measure, consider using an LED candle, especially if the flame would sit close to the cane.
These easy-to-make “hurri-caned” candle holders are a fun project for a craft night. — Mandi
With a glass hurricane, cane webbing, and a few pieces of flat reed, a caned candle holder is a straightforward way to bring woven texture into your home. Measure carefully, use glue sparingly, and keep any open flame well away from the decorative materials.
